LE910Cx Hardware Design Guide
1VV0301298 Rev.40 Page 123 of 149 2023-03-16
Not Subject to NDA
APAC Approvals
13.2.1. Australia RCM
In accordance with the above Approval Compliance Summary table, where applicable
(green ball), hereby, Telit Communications S.p.A declares that the equipment is in
compliance with Regulatory Compliance Mark (RCM) of Australia.
NOTE: The equipment listed may not work when main power fails.
13.2.2. Japan JRL/JTBL Regulatory Notices
Antenna info
According to Japan regulatory rule, module certification is valid only with the specific
antennas registered to and approved by Japan Radio Law (JRL) certified body in relation
to module certification. Customers who are going to use modules under JRL are
responsible to contact Telit technical support or sales to get the list of these antennas.
Dial Function
The Japan Telecommunication Business Law (JTBL) Module Certification for “LE910C1-
AP” and “LE910C1-APX” is for “non-Auto Redial Function” device.
In case customer implement “Auto Redial” function into Application Device by controlling
LE910C1-AP and LE910C1-APX, the customer cannot utilize LE910C1-AP and LE910C1-
APX JTBL certification, and they must apply JTBL as “Application Device” System.
13.2.3. Taiwan NCC Regulatory Notices
According to National Communication Commission (NCC) Taiwan requirements, the
module and the packaging shall be identified as described in the following lines. Shall be
added also the specified safety warning statement.
Brand
name
Telit Telit Telit Telit Telit
Product
name
WWAN module WWAN module WWAN module WWAN module WWAN module
NCC Logo
NCC ID
CCAF19Z10050T8 CCAK22Y00020T2 CCAK22Y00021T4 CCAK22Y00030T5 CCAK22Y00031T7
To Next Page
Loading...
Need help?
General
