LE910Cx Hardware Design Guide
1VV0301298 Rev.40 Page 144 of 149 2023-03-16
Not Subject to NDA
Revision Date Changes
Section 10-3 - Recommended Footprint for the Application updated
for LE910Cx-WWX
Table 20: LE910Cx Current Consumption updated
Section 10.x – Dimension and Mechanical design updated
32 2021-03-23 Section 5.3.3 – Fixed Typo in Note of Section.
Section 8.6 – Update PCM CLK rate.
31 2021-02-05 Table 1: Applicability Table updated
Table4: RF Bands per Regional Variant updated
2.8.1 Dimensions updated
3.1 Note added
30 2021-01-29 Section 2.3 – Added not supported function only based on TreadX OS models
Section 8.5.1 – Updated Note
29 2021-01-12 Updated Section 8.6 – updated I2S diagram
28 2020-12-08 Updated APPLICABILITY TABLE and added notes
Section 3.1 – Updated Pin-out
Section 5.2 – Updated Initialization and Activation figure and added timing table
Section 5.3 – Updated figures
Section 14.1 - Updated FCC/ISED Regulatory Notices
Updated Table 60: RF Bands per Regional Variant
27 2020-07-31 Section 11.4 – Updated EMC Recommendations
26 2020-07-22 7.4 Antenna Diversity Requirements – Note comment changed to AT#RXDIV
14.4 ANATEL Regulatory Notices - Updated
25 2020-06-15 Section 8 – Hardware Interfaces; USB part updated
Section 8.1 – Note Updated
Table 45 and 4 - EUX variant added
Table 46 – CAT 4 DL/UL Tput swapped
Section 14.1 ANATEL Regulatory Notices – Homologation No. fixed
Section 2.7.1 Sensitivity – Sensitivity Table added
Section 2.2. Applications – E-call comment deleted
Table 47 – Sensitivity level changed
Sections 7.4 Antenna Diversity Requirements – Note comment changed
Section 7.5 GNSS Antenna Requirements – Note added
Table 39 – Sensitivity table changed and note added
24 2020-04-29 Section 8.3 – SGMII interface updated
To Next Page
Loading...
