EasyManuals Logo

Telit Wireless Solutions ME910C1 Series User Manual

Telit Wireless Solutions ME910C1 Series
99 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
ME910C1 HW User Guide
1VV0301351 Rev.8 Page 37 of 99 2018-09-28
Figure 1 illustrates a simple circuit to power on the module using an inverted buffer output.
Figure 1: Power-on Circuit
NOTE:
Don't use any pull up resistor on the ON_OFF*/WAKE* line, it is
internally pulled up. Using pull up resistor may bring to latch up
problems on the ME910C1 power regulator and improper power
on/off of the module. The line ON_OFF*/WAKE* must be connected
only in open collector or open drain configuration.
In this document all the lines that are inverted, hence have active low
signals are labelled with a name that ends with”#",”*” or with a bar
over the name.
To check if the device has powered on, the hardware line PWRMON
should be monitored.

Table of Contents

Other manuals for Telit Wireless Solutions ME910C1 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions ME910C1 Series and is the answer not in the manual?

Telit Wireless Solutions ME910C1 Series Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelME910C1 Series
CategoryWireless modules
LanguageEnglish

Related product manuals