12
NOTICE: With Pre-dialing, if you dial the wrong digit you can briefly
press the button to delete one digit at a time. If you press the
button, the entire number will be deleted.
2. Press the button on the handset to dial the number.
NOTICE: You can also press the button first, you will then hear dial
tone. As you enter the digits of the desired number, your telephone will
dial the number immediately. The correction of individual digits is only
possible in the pre-dialing mode.
3.4 Call timer
During a call, the duration of the call is displayed in minutes and
seconds. 5 Seconds after dialling, the display changes from the number
dialed to display the call duration. The call timer will display the call
duration for a few seconds after completion of the call.
3.5 Turning the handset on and off
By holding down the button, you can turn off the handset. If the
handset is turned off, there is no drain on the battery.
Hold down the button again to turn the handset back on. The
message, SEARCHING will flash on the display and the handset will be
ready for use after a brief delay.
NOTICE: No calls can be made or received if the handset is switched
off.
3.6 Range indications
The range of the handset is a maximum 50 metres in enclosed areas
and up to about 300 meters in open areas (line of sight). If a strong
signal is available from the base station a symbol will appear on the
display.
If you move too far away from the base station, the symbol will blink
and you will hear warning beeps. In this case you should move closer to
the base station to avoid losing the connection.
For best performance ensure that the base station is located in the
centre of the area in which the handset will be used most frequently.
This will ensure optimum range and performance.
To Next Page