16
4. The Phonebook
Up to 100 telephone numbers and names can be stored in the
phonebook. The maximum stored number length is 24 digits and name
length is 12 characters.
4.1 Entering numbers in the phonebook
1. Press the MENU button. The display shows PHONEBOOK.
2. Press the MENU button. The display shows NEW ENTRY.
3. Press the MENU button again. The display now shows
ENTER NAME.
4. Now enter the name (up to 12 letters) on the keypad.
Below you will find more information on entering names.
5. Press the MENU button again. The display shows ENTER
NUMBER.
6. Enter the desired number from the keypad.
7. Press the MENU button again.
8. Use the p and q buttons to select NO GROUP, GROUP A, B
or C. This step is to select which ring melody group you wish
the number to belong to (See below).
9. Press the MENU button again to confirm.
10. If you wish to store more phone numbers, go back to step 3.
To exit from the entry mode, press the button.
Further information about the phonebook:
You can assign individual contacts to a specific ring melody group of
your choice. For example, Group A contains phone numbers of all your
co-workers. One of ten ring tones can then be assigned to this group. In
this way, you can tell who is calling you simply from the ring tone.
(Identicall subscription is required to use this feature)
If the memory capacity of 100 numbers has been exceeded, the display
will show MEMORY FULL. In this case, some numbers will have to be
deleted before new numbers can be entered.
How to enter names:
Example: you wish to enter the name, “JARED”.
To do so, press:
5 button once, 2 button once, 7 button three times, 3 button twice, 3
button once.
To Next Page