31
7.11 Setting the alarm
When the alarm is set, the symbol will be displayed.
1. Press the MENU button.
2. Use the pand q buttons to select CLOCK/ALARM. Press
the MENU button.
3. Use the pand q buttons to select SET ALARM. Press the
MENU button.
4. Use the pand q buttons to select OFF, ON ONCE or ON
DAILY. Press the MENU button.
5. If you selected ON ONCE or ON DAILY, enter the time you
want to set the alarm for, e.g. 07 30 for 7:30am, then press the
MENU button.
6. Press the button to return to standby.
NOTE: When the alarm sounds, the display shows ALARM ON. Press
any button on the keypad to turn the alarm off.
7.10 Setting the babysit mode
When you have more than one handset connected to the base station,
this function will allow you to leave one handset in a room and use the
other handset to listen to sounds in that room.
1. Press the MENU button.
2. Use p and qbuttons to select PERSONAL SET. Press the
MENU button.
3. Use pand qto select BABYSIT MODE. Press the MENU
button.
4. Use pand qto select ON or OFF. Press the MENU
button to confirm.
NOTE: When switched on, you can leave this handset in the room you
wish to monitor. Only the microphone is on.
5. Place the handset in a room.
6. On the other handset, press the INT button and enter the
number of the handset you are using as a room monitor. You
can now hear sounds coming from that room.
7. To stop the room monitoring at any time, press the button.
To Next Page