27
7. Additional Functions
Any additional programming functions can be accessed through a very
user-friendly menu. Here is a short guideline to navigate your way
through the menu of your telephone:
To begin programming, press the MENU button.
The p and q buttons are used to search through the function groups.
The group indicated on the display is selected by pressing MENU.
The p and q buttons are now used to search for the desired individual
function, which is again selected by pressing MENU.
The button can be used to move back one level during the
selection process. Any store function will be automatically abandoned if
no selection is made within 15 seconds.
The button can be pressed at any time to exit from the programming
mode without making any changes.
Chapter 7.14 gives a detailed summary of the menu.
7.1 Setting ring melodies on the handset
Your handset offers ten different ring melodies to signal an incoming call.
1. Press the MENU button.
2. Use p and q buttons to select PERSONAL SET. Press
the MENU button.
3. The display shows HANDSET TONE. Press the MENU
button.
4. Use p and q buttons to select RING MELODY. Press the
MENU button.
5. Use p and q buttons to select the desired ring melody then
press the MENU button. The melody will be played.
6. Press the MENU button again to confirm.
7. You can then select further menu functions or exit by pressing
the button.
7.2 Setting the ring melody volume on the handset
The volume of the handset ring melody can be set to one of five levels.
If, at any time, you do not wish to be disturbed, you can also turn off the
ringing signal altogether. If the ringing signal is turned off, the symbol
will be shown on the display and an incoming call will only be signalled
on the handset display.
To Next Page