Telrad BreezeCOMPACT 3000 - Spectrum Analyzer Operation; Spectrum Analyzer Configuration and State; Spectrum Analyzer Scanning Operations

Chapter 3 - Operation and AdministrationSpectrum Analyzer
Chapter 3: Operation and Administration
Spectrum Analyzer
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
BreezeCOMPACT System ManualBreezeCOMPACT System Manual
97
8 – Set Default Configuration
3.11.3 Show Current State
This parameter displays the Spectrum Analyzer state per BS/Sector. It indicates the enabled/disabled state and scanning
state.
3.11.4 Start Scanning
This parameter starts the scanning process.
3.11.5 Abort Scanning
This parameter aborts the scanning state. Results are shown up to the last scanned frequency.