LTE Outdoor CPE | User Manual P. 35
◆ Device Ready: Unlock pin code.
◆ Search: Scan the available eNodeB.
◆ Network Entry: Cell detection.
◆ Attached: As titled.
◆ Idle: As titled.
◆ No Signal: NAS attached RRC detached.
■ DL Frequency: Downlink frequency.
■ UL Frequency: Uplink frequency.
■ Bandwidth: As titled.
■ RSRP0: Reference signal receiving power of path 0.
■ RSRP1: Reference signal receiving power of path 1.
■ RSRQ: Reference signal receive quality.
■ CINR0: The quality of the signal of path 0.
■ CINR1: The quality of the signal of path 1.
■ SINR0: Signal to interference plus noise ratio of path 0.
■ SINR1: Signal to interference plus noise ratio of path 1.
■ TX Power: Transmission power.
■ PCI: Physical cell identity.
■ Cell ID: Cell Identity, a part of cell global identification.
■ eNodeB ID: Identity of connected eNodeB.
● UpLink Status
■ Data Rate: The upload speed.
■ TX Bytes: Number of sending bytes.
■ Packets: Number of sending packets.
● DownLink Status
■ Data Rate: The download speed.
■ RX Bytes: Number of received bytes.
■ Packets: Number of received packets.
To Next Page
Loading...