Page 13 of 14
Don’t use the modem immediately after a sudden temperature change eg from an air conditioned
environment to high temperature and humidity outside. In such cases there could be condensing moisture inside
the modem which can cause internal damage. Unplug the modem and leave it for 30 minutes before use.
Always handle the modem with care. Be careful not to drop or bend the modem.
There are no user serviceable parts inside the modem. Unauthorised dismantling or repair will void the
warranty.
Do not disassemble the case. Internal parts such as button cells may be fatal if swallowed.
Do not dispose of the unit in a fire, the battery may explode.
At the end of life of the equipment, return the product to a suitable recycling agent such as Mobile Muster.
RF SAFETY INFORMATION
For optimum performance with minimum power consumption do not shield the device or cover with any object.
Covering the antenna affects signal quality and may cause the modem to operate at a higher power level than
needed.
RADIO FREQUENCY ENERGY
The USB modem is a low-power radio transmitter and receiver. When switched on it intermittently transmits
radio frequency (RF) energy (radio waves).
The transmit power level is optimized for best performance and automatically reduces when there is good quality
reception.
Maximum power is only used at the edge of network coverage so under most circumstances the power output is
very low.
Under poor network conditions the modem transmits at a higher power level and may get hot.
To Next Page
Loading...
