Teltonika FMC920 - PC CONNECTION (WINDOWS); HOW TO INSTALL USB DRIVERS (WINDOWS)

Quick Manual v1.0 // FMC920
7
Telematics
PC CONNECTION (WINDOWS)
HOW TO INSTALL USB DRIVERS (WINDOWS)
1. Please download COM port drivers from here
1
.
2. Extract and run TeltonikaCOMDriver.exe.
3. Click Next in driver installation window.
4. In the following window click Install button.
5. Setup will continue installing the driver and eventually the conrmation window will appear. Click Finish to complete the
setup.
1
teltonika-gps.com/downloads/en/FMC920/TeltonikaCOMDriver.zip
1. Power-up FMC920 with DC voltage (10 – 30 V) power supply using power wires. LED’s should start blinking, see “LED
indications
1
”.
2. Connect device to computer using Micro-USB cable or Bluetooth connection:
• Using Micro-USB cable
• You will need to install USB drivers, see “How to install USB drivers (Windows)
2
”
• Using Bluetooth
• FMC920 Bluetooth is enabled by default. Turn on Bluetooth on your PC, then select Add Bluetooth or other device >
Bluetooth. Choose your device named – “FMC920_last_7_imei_digits”, without LE in the end.
• Enter default password 5555, press Connect and then select Done.
3. You are now ready to use the device on your computer.
1
Page 13, "LED indications"
2
Page 7, "How to install USB drivers (Windows)"