Tenda 4G03 Pro - Acronyms and Abbreviations

Document Version: V1.1
106
10.7 Automatic maintenance
Automatic maintenance enables you to make the router restart regularly, improving the stability
and service life of the router. This function is enabled by default.
To access the page, log in to the web UI of the router, and navigate to System Settings > Automatic
Maintenance.
Parameter description
Parameter
Description
System Reboot Schedule
Used to enable or disable the automatic reboot function.
Reboot At
Specifies the time when the router reboots automatically every day.
Delay
Used to enable or disable the delay function.
−
Ticked: The function is enabled. When the time for rebooting
approaches, if there is any user connected to the router and the
traffic over the router's WAN port exceeds 3 KB/s within 30 minutes,
the router will delay rebooting. If there is any user connected to the
router and the traffic over the WAN port does not exceed 3 KB/s
within 30 minutes, or there is no user connected to the router and the
traffic over the router's WAN port is slower than 3 KB/s within 3
minutes, the router will reboot automatically.
−
Unticked: The function is disabled. The router enters the sleeping
mode during the sleeping time.
When the system reboot schedule function is enabled, the router detects the
traffic over the WAN port continuously within 2 hours after the specified reboot
time and reboot when the traffic requirement for rebooting is met.