Tenda 4G03 Pro - Wps; Overview; Connect Devices to the Wi-Fi Network Using the WPS Button

Document Version: V1.1
50
6.3 WPS
6.3.1 Overview
The WPS function enables wireless devices, such as smartphones, to quickly and easily connect to
Wi-Fi network of the router without entering the Wi-Fi password. There are two ways to connect
devices to the Wi-Fi network.
−
Connect devices to the Wi-Fi network using the WPS button
−
Connect devices to the Wi-Fi network through the web UI of the router
To enable or disable the WPS function, log in to the web UI of the router, and navigate to Wi-Fi
Settings > WPS.
− This function is only applicable to WPS-enabled wireless devices.
− If the WPS function is disabled, the internet cannot be connected through the WPS function of
the router.
6.3.2 Connect devices to the Wi-Fi network using the WPS
button
Step 1 Find the WPS/RST button on the rear panel of the router, and hold it down for 1 to 3
seconds. The Wi-Fi indicator blinks slow.
Step 2 Configure the WPS function on your wireless devices within 2 minutes. Configurations on
various devices may differ (Example: HUAWEI P10).
1. Find Settings on the smartphone.
2. Tap WLAN.
3.
Tap , and choose WLAN settings.