Document Version: V1.1
44
Procedures:
Step 1 Connect the WAN/LAN port of the router to the LAN port of your smart home gateway.
Step 2 Log in to the web UI of the router.
Step 3 Navigate to Internet Settings.
Step 4 Enable the Failover function.
Step 5 Set Connection Type to PPPoE, and enter the PPPoE Username and PPPoE Password
provided by your ISP.
Step 6 Click Connect.
---End
When the figure is shown below on the Internet Status page, the router is connected to the
internet successfully and you can enjoy uninterrupted internet access guaranteed by both the
broadband and SIM card.
To Next Page
Loading...
