EasyManuals Logo

Tenda O3 User Manual

Tenda O3
198 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #102 background imageLoading...
Page #102 background image
94
Parameters description
Name
Description
DHCP Server
It specifies whether to enable the DHCP server function of the device. By default, it
is enabled.
Start IP Address
It specifies the start IP address of the IP address pool of the DHCP server. The
default value is 192.168.2.100.
End IP Address
It specifies the end IP address of the IP address pool of the DHCP server. The
default value is 192.168.2.200.
The start and end IP addresses must belong to the same network segment as the IP
address of the LAN port of the device.
Subnet Mask
It specifies the subnet mask assigned by the DHCP server to clients. The default
value is 255.255.255.0.
Gateway Address
It specifies the default IP address gateway assigned by the DHCP server to clients.
Generally, it is the IP address of the LAN port of a router on the LAN. The default
value is 192.168.2.254.
A client can access a server or host not in the local network segment only through
a gateway.
Primary DNS Server
It specifies the primary DNS server IP address assigned by the DHCP server to
clients. The default value is 8.8.8.8.
To enable clients to access the internet, set this parameter to a correct DNS server
IP address or DNS proxy IP address.
Secondary DNS Server
It specifies the secondary DNS server IP address assigned by the DHCP server to
clients. This parameter is optional.
Lease Time
It specifies the validity period of an IP address assigned by the DHCP server to a
client.
When half of the lease time has elapsed, the client sends a DHCP request to the
DHCP server to renew the lease time. If the request succeeds, the lease time is
extended according to the request. Otherwise, the client sends the request again
when 7/8 of the lease time has elapsed. If the request succeeds, the lease time is
extended according to the request. Otherwise, the client must request an IP
address from the DHCP server after the lease time expires.
It is recommended that you retain the default value.

Other manuals for Tenda O3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tenda O3 and is the answer not in the manual?

Tenda O3 Specifications

General IconGeneral
5 GHzNo
2.4 GHzYes
Number of users15 user(s)
Transmitting power29 dBmW
Networking standardsIEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Receiver sensitivityMCS0: -88dBm MCS7: -72dBm
Maximum outdoor range5000 m
Maximum data transfer rate150 Mbit/s
USB 2.0 ports quantity0
Ethernet LAN (RJ-45) ports1
PlacementWall
CertificationFCC / CE / RoHS
Product colorWhite
LED indicatorsLAN, Power, WAN
International Protection (IP) codeIP64
Antenna featuresIntegrated antenna
Antenna gain level (max)12 dBi
Output current1 A
Output voltage12 V
Power consumption (max)6 W
Security algorithmsWPA, WPA2, WPA2-PSK
Cables includedLAN (RJ-45)
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)-20 - 55 °C
Operating relative humidity (H-H)10 - 90 %
Weight and Dimensions IconWeight and Dimensions
Depth94.86 mm
Width270 mm
Height67.5 mm

Related product manuals