131
Parameters description
It specifies the SSID of this device. With the rule enabled, clients connected to the
network with this SSID will be controlled by the rule.
It specifies whether to enable the Access Control function.
It specifies the mode for filtering MAC addresses.
Allow: It indicates that only the wireless clients on the access control list can
connect to the WiFi network of the device.
Disallow: It indicates that only the wireless clients on the access control list cannot
connect to the WiFi network of the device.
7.3.3 Example of configuring access control
Networking requirement
A wireless network whose SSID is Connect me has been set up in a residential community. Only
the community members are allowed to connect to the wireless network.
The Access Control function of the CPE is recommended. Assume that the users have three
wireless devices whose MAC addresses are C8:3A:35:00:00:01, C8:3A:35:00:00:02, and
C8:3A:35:00:00:03.
Configuration procedures
Step 1 Start a web browser on the computer connected to the CPE, visit 192.168.2.1 and choose
Wireless > Access Control, and enable the Access Control function.
Step 2 Set the Mode to Allow.
Step 3 Enter the MAC address, which is C8:3A:35:00:00:01 is this example, and click Add.
Step 4 Perform Step 3 to add the other two MAC addresses.
Step 5 Click Save.