Tenda O3

9

If the LED1, LED2 and LED3 indicators of a new-added CPE turn off after it is powered on for 1
minute, the bridging fails. Reset the CPE to factory settings, and wait until its LED1, LED2 and LED3
indicators keep blinking.

When using O2 to perform peer-to-multiple peers bridging, after the peer-to-peer bridging
succeeds, place the rest CPEs which are in factory settings near the CPE with the LED1, LED2, and
LED3 indicators solid on and power them on in 3 minutes.

If the bridging still fails, try manual bridging. Refer to Client mode for details
Option 2 Manual bridging
Step 1 Place the two CPEs next to each other.