System Administration
- 9 -
3. Confirm Password: enter the password once again;
4. Click OK
The switch will reboot automatically when new user name and password are created. The
new user name and password are required for the next access to the Web administration.
2.3 Reset
The function of reset is available when you want to clear all configurations and restore the
switch to factory default settings.
Click Administration > Reset to enter the page below.
In case of forgetting IP login address or user name/password, you can use the Reset button
to reset the switch. The procedures are shown below:
1. Under power-up state, use a needle-shaped object to press the Reset button on the front
panel of the switch for 6s seconds;
2. Wait for about 20 seconds until SYS LED is blinking again.
Tip
Upon resetting the switch”, IP address is “192.168.0.1”, user name and password are both
“admin”.
2.4 Reboot
Reboot the switch to release partial cache, remove unwanted messages, thus to keep it
To Next Page
Loading...
