Tenda TEF1210P-8-150W - Configuring MAC Binding

Device Management
- 56 -
8.1.2 Configuring MAC Binding
Click Device Management to enter the configuration page.
Specification of parameter settings:
Header entry
Description
Select port
Select a port whose static MAC address binding function needs to be
configured.
Static MAC
Address 1
Static MAC
Address 2
Static MAC
Address 3
Enter an access device MAC address bound to this port. The switch
supports binding up to three access devices (MAC addresses are
different).
Note
Broadcast or multicast address binding is not allowed.
Binding
Enable/Disable the MAC binding function of this port.
Tip
 Ports whose MAC binding function is enabled will disable the
address learning function.
 After the MAC binding function is enabled, the switch only allows a
designated device to access the network through this port.