Port Management
- 18 -
The Port Mirroring Type Supported by the Switch
The local port mirroring that the source and the destination port are on the same switch is
supported by the Tenda Smart PoE Switch.
3.2.2 Port Mirroring Configuration
Click Port Management > Port Mirroring to enter the page below.
How to configure port mirroring:
1. The mirroring destination port: Select a port as the destination port;
2. The mirroring status: Select the port as the source port mirroring and check the
corresponding mirroring status box;
3. The mirroring direction: Select the direction;
4. Click OK
Parameter specification:
Select the mirroring destination port of the switch. The blank is perceived
to close the mirroring function.
The bandwidth of the sole mirroring destination port is supposed to be
more than or equal to the sum of source ports.
Note
The same port is not allowed to be set as the destination port and the
source one at the same time.
The source ports can be set conditioning the already set destination
To Next Page
Loading...
