VLAN Management
- 38 -
7.2.2.2 VLAN Division
This part takes the form of example to describe how to add, delete and modify port VLAN
and how to restore VLAN port configuration to the factory settings.
Add Port VLAN
Suppose to add the port 2, 3, G1/SFP1, G2/SFP2 to VLAN2.
Configuration Steps:
1. Log in the Web administration and go to VLAN Management > Port VLAN page;
2. Select: Check the before Port No. and select the port to be set;
Tip
Check the at the top to select all of ports.
3. VLAN List: In the following input box, enter the VLAN ID of the port selected in the Step 2;
4. Operate: Click +Add to end the setup. The outcome is shown in the page below.
To Next Page
Loading...
