Device Management
- 80 -
Configuration procedures:
1. Log in to the Web network management of the switch, and then go to Device
Management > SNMP > Trap Configuration page;
2. SNMP Trap: Click the drop-down box, and select the Enable;
3. Trap Destination IP: Enter the IP address of SNMP administrator;
4. Click OK
Parameter specification:
Enable the Trap function, and set the Trap destination IP address.
In case an emergency milestone occurs on the switch, transmitting Trap
information will be transmitted to the SNMP administrator on the host in
which the Trap destination IP address is available.
Tip
Trap destination IP address can only be set to a legal single-machine
address falling within the same network segment as the switch, and no
exceptional IP address can enable the Trap function.
To Next Page
Loading...
