300Mbps Wireless Access Point
4.4 Access Control
To secure your wireless LAN, the wireless access control is actually
based on the MAC address management. Select “Wireless
Setting->Access Control” to display the following screen:
Setting Explanation:
² MAC Address Filter Enable/disable MAC address filter. Select
“Close” to malfunction MAC address; “disable” to prevent the MAC
addresses in the list from accessing the wireless network; “Allow” to
allow the MAC address in the list to access the wireless network.
² MAC Address Management Input the MAC address to implement
the filter policy. Click “Add” to finish the MAC add operation.
² MAC list Show the added MAC address. You can add or delete
them.
Note: This AP can support no more than 32 MAC addresses.