IB 340405 (05--2007) 1
No. 340405
Machine: 5680
Published: 05--2007
Rev: 02
INSTRUCTION BULLETIN
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the Parts
List in the appropriate place in the machine manual for future reference.
Retaining th e Parts List will make it easier to reorder individu a l p arts and will
save the cost o f ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit number 397745
SYNOPSIS:
This kit contains the parts needed to install a 700D scrub head on the 5680 scrubber.
Please follow step-by-step instructions.
SPECIAL TOOL S / CONSIDERATIO NS: NONE
(Estimated time to complete: 1 hour)
PREPARATION:
1. Stop the machine on a level clean surface, lower
the scrub head, and turn off the machine.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off machine,
and remove key.
2. Remove the front cover from the machine.
3. Disconnect battery cables from the batteries.
W ARNING: Always disconnect battery
cables from machine before working on
electrical components.
REMOVE THE OLD SCRUB HEAD:
NOTE: Refer to FIG. 11 and FIG. 12 for detailed
drawings of parts assembled throughout this
Instruction Bulletin.
1. Disconnect the solution line from the tee fitting.
Refer to FIG. 1.
FIG. 1
2. Disconnect the wire harness from the old scrub
motors. Refer to FIG. 2.
FIG. 2
3. Disconnect the scrub head from the guide by
removing the clevis pin. Refer to FIG. 3.
FIG. 3
To Next Page
Need help?
General
