Tennant 7100 Instruction Bulletin

IB 340425 (1-01) 1
No. 340425
Machine: 7100
Published: 1-01/01
System: OPTIONS
INSTRUCTION BULLETIN
NOTE: DO NOT DISCARD the Parts List from the Instructi on Bulletin. Place the Parts
List in the appropriate place in your machine manual for future reference.
Retaining th e Parts List will make it easier to reorder individual parts an d will
save you the co st of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit number 391041
SYNOPSIS / PROBLEM:
This kit contains the parts needed to install an Extended Scrub kit on the m odel 7100
scrubber.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 3 hours)
PREPARATION:
(Refer to FIG. 1 thru 5)
1. Check solution and recovery tanks. If tanks are not empty, drive machine to a proper
solution drain. Empty the solution and recovery tanks.
FOR SAFETY: Before leaving or servicing machine, sto p on level surface and set parking
brake. T h en turn off machine and remove key.
2. Drive machine to a clean and level work area. Disconnect battery cables from machine.
WARNING: Always disco n n ect battery cables from machine before working
on electrical components.
ESt
tt
t KIT INSTALLATION:
(Refer to FIG. 1 thru 5)
1. Disconnect, remove and set aside the drain caps
and hoses from both tanks. Remove and set aside
the drip shield and two mounting bolts.

Tennant 7100 Specifications

General

Power Source	Battery
Machine Type	Ride-on Scrubber
Battery Voltage	24 V
Cleaning Path	28 in / 710 mm
Cleaning Path Width	28 in / 710 mm