Why is my Tennant Scrubber leaving water behind?
If your Tennant Scrubber isn't picking up water effectively, several factors could be at play. Ensure the scrubbing mode is correctly set. Check and clean the squeegee blades, shut-off float, and vacuum intake screen for any obstructions. If the squeegee blades or tank cover gaskets are worn or damaged, replacement is necessary.
How to fix a Tennant Scrubber that won't turn on?
If your Tennant Scrubber won't turn on, the issue might stem from a faulty power cord, in which case you should replace the power cord. Another potential cause is a tripped circuit breaker. Unplug the power cord, determine what caused the breaker to trip, and then reset the 7.5 amp circuit breaker button.
Why my Tennant T1 does not operate?
If your Tennant Floor Machine isn't turning on, there are several potential causes. First, ensure the battery is charged; if it's discharged, charge it. Check that the charger plug is disconnected. A defective battery could also be the problem, requiring a replacement. Lastly, verify that the battery cable connections are secure and tight.
What to do if Tennant T1 has poor solution pickup?
If your Tennant Floor Machine isn't picking up solution effectively, consider these possibilities. Ensure the machine is not in transport position and lower the scrub head to the floor. If the recovery tank is full, empty it. Check for clogged squeegee blades or inlet openings and clean any debris. Replace worn or damaged squeegee blades, and clean any debris from the shut-off float or vacuum intake screen.
Why there is no vacuum on my Tennant Floor Machine?
If there's no vacuum in your Tennant Floor Machine, first, ensure the vacuum switch is activated. Also, check if the vacuum circuit breaker has tripped. If it has, turn off the main power switch, remove any obstruction, and then reset the circuit breaker.
Why is my Tennant Floor Machine not operating?
If your Tennant Floor Machine isn't operating, consider these potential causes: * The battery may be discharged, in which case you should charge it. * If the charger plug is connected, disconnect it. * The battery could be defective, requiring replacement. * Check for loose battery cable connections and tighten them.
What to do if Tennant Floor Machine has no vacuum?
If there is no vacuum in your Tennant Floor Machine, check the following: * Ensure the vacuum switch is activated by turning it on. * If the vacuum circuit breaker has tripped, turn off the main power switch, remove any obstruction, and reset the circuit breaker.
What to do if my Tennant Floor Machine does not operate?
If your Tennant Floor Machine isn't operating, the issue might stem from a faulty power cord, which requires replacement. Alternatively, a tripped circuit breaker could be the culprit. In this case, unplug the power cord, identify the cause, and reset the 15 amp circuit breaker button. If the breaker continues to trip, it's best to contact a service center.
Why is the water pickup poor on my Tennant Floor Machine?
Poor water pickup in your Tennant Floor Machine can arise from several factors. Ensure the scrubbing mode switch is correctly set. Check for and remove any debris from the squeegee blades, shut-off float, and vacuum intake screen. If the squeegee blades or tank cover gaskets are worn or damaged, replace them. For clogged vacuum hose or faulty vacuum motor, contact a service center.
What to do if the brush does not spin on my Tennant Floor Machine?
If the brush on your Tennant Floor Machine isn't spinning, a tripped circuit breaker might be the cause. Unplug the power cord, check the brush for any obstructions, and then reset the 5 amp circuit breaker button. If that doesn't solve the problem, the brush belt might be broken, or the brush motor could be faulty, or the carbon brushes worn; in any of these cases, contact a service center.
General| Brand | Tennant |
|---|---|
| Model | T1 |
| Category | Floor Machine |
| Language | English |
To Next Page
