Tennant T5 - Operator Safety and Warnings; General Safety Instructions

On--Board Charger Kit
INSTALLATION INSTRUCTIONS --
Continued
Page4of4
KIT NO. 9003295 (120v), 9003296 (230v)
9003301 Rev. 00 (01--07) Tennant Company Customer Service: (800) 553--8033 or (763) 513--2850
ON--BOARD BATTER Y CHARGER SETTINGS
The charger settings must be set for your battery
type before charging. Failure to properly set will
result in battery damage.
To determine your battery type, see battery
label. Contact your battery supplier if not speci-
fied.
To verify the setting of the charger, connect the
charger cord into an electrical receptacle. The
charger will display a sequence of codes. One of
the codes will either read “GEL” or “Acd”
(Figure 13).
GEL = Set for sealed/maintenance free batteries
Acd = Set for wet/lead acid batteries
Fig. 13
To change the setting, unplug the charger, peel
up the corner of the display label and set the
switches accordingly (Fig. 14). The charger cord
must be unplugged when resetting.
WET “Acd” BATTERY
SEALED “GEL” BATTERY
Fig. 14
Home
Find...
Go To..