To Next PageTo Next PageWhy is my Tennant Scrubber having poor scrubbing performance?
If you're experiencing poor scrubbing performance with your Tennant Scrubber, here are a few things to check: * Debris might be caught in the brush or pad. Remove any debris that you find. * The brush or pad could be worn, so consider replacing it. * The brush pressure might be incorrect; adjust it accordingly. * The battery charge might be low; recharge the batteries.
Why does my Tennant T600e have a short run time?
If your Tennant Scrubber has a short run time, the issue could be due to a low battery charge, so try charging the batteries. Alternatively, the battery might be defective or at the end of its life, in which case you should replace it.
How to fix Tennant T600e Scrubber on-board battery charger that will not operate?
If the on-board battery charger of your Tennant Scrubber won't operate, first check the plug connection to the power supply. If that's not the issue, the batteries might be over-discharged and need replacing. For a battery charger fault, refer to SERVICE INDICATOR CODES.
Why is there little or no solution flow in my Tennant T600e Scrubber?
If your Tennant Scrubber has little to no solution flow, it may be due to an empty solution tank; refill the solution tank. Alternatively, the solution flow rate may be set too low; increase the solution flow rate.
What to do if my Tennant Scrubber machine will not propel?
If the Tennant Scrubber machine will not propel, a propel fault may have been detected; refer to SERVICE INDICATOR CODES. Another possibility is a tripped circuit breaker (T600e); reset the circuit breaker.
General| Power Source | Battery |
|---|---|
| Machine Type | Walk-behind |
| Battery Voltage | 24 V |
| Sound Level | 67 dBA |
| Battery Type | Lead-acid |
| Machine Height | 43 in / 1, 090 mm |
