8
DEVICE LIST
Once your devices have been added to the list, you can check the most
important status information of each unit at a glance. You will be able to
monitor the level meter, recording file format, recording time, frame rate,
timecode, battery status, Bluetooth range, device icon and name.
If a TRACK E is out of Bluetooth range for more than 10 seconds, the
status and timecode of it will be maintained. If the app hasn’t received any
updates for more than 10 minute, the message will be Last seen x minutes
ago.
Depending on the physical distance of a Tentacle device to your mobile
device, the status information in the list will be highlighted. The closer the
TRACK E gets to your mobile device the more saturated the color will be.
Remove a TRACK E from the device list
You can remove a Tentacle. TRACK E from the list by swiping
to the left (iOS) or long pressing (more than 2 sec.) on the Tentacle status
information (Android).
DEVICE WARNINGS
Devices have to be synchronized: This warning message is displayed,
when inaccuracies of more than half a frame occur between all devices in
Green Mode. Sometimes this warning can pop up for a few seconds, when
starting the app from background. In most cases the app just needs some
time to check the information of each Tentacle device. However, if the
warning message persists for more than 10 seconds you should consider
re-syncing your Tentacles.
To Next Page
Loading...
Need help?
General