TENVIS Technology Co., Ltd.
8
3. When the Wi-Fi is successfully configured, you can now disconnect
the network cable from your camera and start using your camera as a
wireless device.
*Notice: Please wait for at least 30s (maximum to 1 minute) for Wi-Fi mode
to be completely functional.
*Tips: If your router has a WPS button, you could set up wireless LAN
easily by using the WPS button on the camera and the router by the
operation steps on Page 36.
1. U
nplug the AC power adapter from the camera; insert a micro SD
card (sold separately). Plug the AC power adapter back to the camera
and wait for it to reboot.
2. T
ap on Record in settings and select the mode to record to micro SD
card. Choose between Full time for continuous recording, or Alarm
for recording while motion is detected. The camera will reboot after
saving Record settings
Alarm Setup
To Next Page
Loading...
