GB
English
Instruction Manual
Multi 250 - 400K - 500F - 500K - 500 MAR e Accessories
18. MIGMAG MODE
18.1 Wire spool loading - Mig-Mag Mode
The wire feeder unit can receive 200 or 300 mm size wire spools. Make sure your
wire spool is correctly and safely xed to the pinion than adjust the friction screw:
a) match the driving rolls located into the driving motor with your wire type and
size
b) insert the wire into the driving rolls and push it till the machine euro adaptor.
Lock the driving rolls properly
c) connect the mig torch to the machine euro adaptor
d) press the torch trigger: wire drives for 5 sec. and stops once the display will
light “INC 10”
e) release the torch trigger and press it again: wire drives now into the torch at
approx 10 mt/min, until trigger remain pressed
f) shielding gas hose is tted to the back panel of the machine (gas nipple
marked with MIG). Adjust the ow rate between 16/22 lt/min. depending on the
welding task
g) connect the earth clamp plug to the negative polarity
This procedure is valid even for the LPM remote wire feeder unit.
Now you can select your Mig welding mode between:
MIG-MAG - MANUAL
MIG-MAG - SYNERGIC
PULSED MIG
PULSED MIG – DOUBLE PULSED
19. MIG/MAG MANUAL
Setting available for generators Serie “K” and Serie “K + DUO”:
19.1 Wire Speed Setting - Mig/Mag manual
To Next Page
Loading...
