Set selector switch (J) to the required number of
shakes.
The standard setting is 0x, 1x, 2x or 3x shaking.
20 EN
EN
3. Bin lift operation
37878
05-2017
3.9
Shake function 2W bins (Green waste)
ã Terberg Machines B.V., IJsselstein, The Netherlands
All rights reserved. No part of this book may be reproduced, stored in database or retrieval system, or published, in any form or in any way,
electronically, mechanically, by print, photoprint, microfilm or any other means without prior written permission from the publisher.
Only give an extra shake if there is a need for
this. Shaking takes time and causes extra
noise for the surrounding area.
If refuse (Green waste) remains stuck in the bin,
y
ou can use the shake function. This function is
only available with automatic loading.
The standard setting is 0x, 1x, 2x or 3x shaking.
The number of shakes can be adjusted to client's
r
equirements.
See chapter 3 - Diagnostic System, par. 3.11.5 -
Settings: Shaking.
This shake function is only available with
automatic loading
. With manual loading, you
can apply extra shake by keeping the UP
button pressed.
3.10
Transport and travel positions
The bin lift may never be operated when the
refuse collection vehicle is travelling along and
also not when reverse gear is engaged.
Never stand on other parts of the bin lift and
also never use them as a seat,
this is
extremely dangerous!
TRANSPORT position
For sufficient bottom clearance, the lifting chairs
must be set to the highest position with the optional
pick-up arms folded in and the optional footboards
folded up when:
- Driving to and from a collection area.
- Driving over large obstacles or over uneven
terrain.
- Parking.
TRAVEL HEIGHT position
To avoid damage to the bin lift, the OmniDEKA is
fitted standard with the travel height function.
When this function is activated, both lifting chairs go
to the travel height.
Press the black button (D), on
one of the two button control
stations.
Both lifting chairs go to the travel
height.
Reversing
When reversing of the refuse collection vehicle is
activated, the bin lift will automatically lift both lifting
chairs to a manoeuvring height. If automatic lifting is
not done, for instance with a deactivated PTO, a
warning signal will sound in the cabin after a few
seconds to warn the driver that the bin lift is not at
the travel height.
When somebody is standing on the footboard:
•
Reversing is not allowed.
•
The refuse collection vehicle may run no faster
than 30 km/h.
•
The compactor may not be running automatically.
To Next Page
Loading...
