SoundSystem SiXPack 5.1 + 43
Differences in the sound reproduction from different digital cables sounds crazy at first glance,
but they can occur. This is proven, among other things, by the fact that error correction algo-
rithms are obviously used more frequently at some times than at others to correct cables of
differing qualities. In any case these audio changes are usually so minimal that you need to be
careful not to mix up the myth with the reality. If you are interested: there are many somewhat
entertaining militant newsgroups dealing with this subject on the Internet ;-).
Last but not least some information about the transfer protocol: Only data following the S/PDIF
(Sony/Philips digital interface) standard is transmitted over the optical interface. The connec-
tion of ADATs or compatible devices is not supported.
Also devices with AES/EBU interfaces normally can't be used - the ambitious attempt to build
an adaptor will get you nowhere. Because the AES/EBU protocol is nearly identical to S/PDIF
and the transmission essentially only differs in the signal strength, you can make your own
converter with just a little soldering.
A small diagram and further information can be found in the Internet or in the following dia-
gram as well:
AES/EBU to S/PDIF
AES Out: 2-------330 ohm------------------- SPDIF in
|
3--- 91 ohm
| |
1---------|-----------------------
-
ground
To Next Page
Loading...
