TES TES-133 - Page 7

5
4.
Data-Hold key :
1 Press key to hold data, the D-H annunciator is displayed,
press this key again to exit this mode.
2 Press key for 3 seconds to enter the auto hold mode, the
A-H annunciator is displayed, press key for 3 seconds to
exit this mode.
3 Press and hold down key, then press key to turn on
the meter, the auto power off function will be disabled, and the
auto power off symbol “ ” will be disappear.
5. key : Press key to enter the zero mode, the
“ZERO” annunciator is displayed, press this key again to exit
this mode.
6. key : Press key to enter the setting mode, press
key to exit this mode.
1 Press key to setting the sort tolerance limits.
2 Press key to setting the comparator High / Low values.
3 Press key to setting the auto datalogging interval time.
4 Press key to setting the calibration factor value.
5 Press key to setting the reference value.
7. key : Press key to enter the ratio mode, the “RATIO”
annunciator is displayed, press this key again to exit this mode.
8.
key :
1 Press key to enter the sort mode, the “SORT”
annunciator is displayed, press this key again to exit this mode.