TES TES-133 - Page 8

6
2 Press
key first then press key to enter the sort
tolerance limits setting mode.
9. key :
1 Exit a setting mode or store the displayed setting.
2 Exit the READ and Auto datalogging mode.
10. key :
1 Press key to enter the comparator mode, the COMP
annunciator is displayed, press this key again to exit this mode.
2 Press key first then press key to enter the
comparator value setting mode.
11. key :
1 Press key one time to store one set LCD reading to
memory.
2 Press key for 3 seconds to enter or exit auto
datalogging mode.
3 In the reference value setting mode and the comprator value
setting mode, press
⊳
key to move the decimal point left to the
desired position.
4 Press and hold down key then press key to turn on
the meter to enter the clear manual and auto memorized data
mode.
5 Press key first then press key to enter auto
datalogging interval time setting mode.
12.
key :
1 Press key to enter the read mode, the R annunciator is
displayed, press key to exit this mode.