7
2 Press
key for 3 seconds to turn on the RS232 interface.
3 In the reference value setting mode and the comprator value
setting mode, press
key to move the decimal point right to
the desired position.
13. key :
1 In the setting mode press
key to increase the setting value.
2 In the READ mode press
key to increase the memory
location.
3 Press key first then press key to enter the
calibration factor setting mode.
14. key :
1 In the setting mode pess
key to decrease the setting value.
2 In the READ mode press
key to decrease the memory
location.
3 Press key first then press key to enter the SORT
and RATIO reference value setting mode.
4 Press key to display the reference value, press this key
again the reference value is disappeared.
15. Integrating sphere.
16. Port Adaptor kit :
2mm Adaptor size.
3mm Adaptor size – (T1)
4mm Adaptor size
5mm Adaptor size – (T1-3/4)
8mm Adaptor size
10mm Adaptor size – (T3-1/4, T3-3/4)
24mm Adaptor size
17. AC adaptor socket (9V, 100mA).
18. RS232.
To Next Page
Loading...
