To Next PageTo Next Page
Need help?Do you have a question about the TESA Micro-Hite 10 and is the answer not in the manual?
General| Resolution | 0.001 mm |
|---|---|
| Output interface | RS-232 |
| Operating temperature | 10-40 °C |
| Storage temperature | 0-50 °C |
| Accuracy | ±0.002 mm |
| Display Type | LCD |
| Power Supply | Battery |
| Repeatability | 0.0001 mm |
Steps for disassembling the base component of the instrument.
Steps for reassembling the base component of the instrument.
Adjusting potentiometers P1 to P8 for the measuring head board.
Setting maximum gain for 0° and 180° positions.
Setting maximum gain for 90° and 270° positions.
Adjusting gain and offset for the first amplifier.
Adjusting phase for 90° and 270° positions.
Adjusting gain for the second amplifier.
Procedures for locating and using a reference mark for calibration.
Adjusting mechanical axis stops using a dynamometer.
Adjusting the resistive track for accurate measurements.
Adjusting mechanical stops using specific tools and measurements.
Adjusting the tension of the drive cable for proper function.
Verifying the low battery indicator and function.
Procedure for replacing the buzzer component on the instrument.
Information regarding spare parts for older Micro-Hite models and compatibility.
Statement on B&S TESA SA's responsibility regarding software use.
