TESA-hite 400 / 700
7.2 Charging the battery
First of all, you should know that new batteries or batteries that are not used for a long period of time
only attain their full performance after 30 to 40 charges.
Fully recharging the battery pack with the mains adaptor N° 04761054 requires about 8 hours. The
TESA-Hite 400 / 700 M can then be used for about 60 hours. If the battery charge is not sufficient
(under 5,8 V), the battery symbol appears on the display. The operator can continue with the
measurements for about 15 minutes. Once this time has gone, the operating function will deteriorate.
For charging batteries, use only the original adaptor N° 04761054 and proceed as follows:
– Connect mains adaptor to the socket located on the back of the TESA-Hite 400 / 700.
– Connect adaptor to the mains 110 to 240 Vac / 50 to 60 Hz with connecting cable supplied.
– Complete charging takes about 8 hours.
– After full recharging, the adaptor may remain connected to the mains up to max. 24 hours
without danger to the battery.
– During the recharging it is still possible to use the instrument; the time necessary for the
recharge will simply be longer.
Note
Unused batteries will gradually lose charge as time goes by and, if not recharged, deteriorate. They
must therefore be charged at intervals which do not exceed 6 months.
8 DELIVERY PROGRAMME
The order numbers are the following:
TESA-Hite 400 00730043
TESA-Hite 700 00730044
Each TESA-Hite is supplied with the following standard accessories:
- 1 Standard insert holder 00760143
- 1 Standard hard metal measuring insert with a 5 mm t.c. ball tip 00760227
- 1 Master piece with nominal dimension 6.350 mm / 0.2500 in 00760219
- 1 Electric pump for creating the air-cushion 00760142
- 1 Rechargeable 6V battery 00760157
- 1 Mains adaptor 110 to 240 Vac / 50 to 60 Hz 04761054
- 1 Cable EU 04761055
- 1 Cable US 04761056
- 1 SCS calibration certificate
- 1 Instruction manual with a declaration de conformity
- 1 Shipping box
45
To Next Page