Need help?Do you have a question about the TESA CLINOBEVEL 2 and is the answer not in the manual?
General| Brand | TESA |
|---|---|
| Model | CLINOBEVEL 2 |
| Category | Measuring Instruments |
| Language | English |
Details the primary functions of ON/MODE, ZERO/SELECT, ENTER, HOLD, and SEND/ESC keys.
Explains specific operations and modes associated with each function key.
Overview of display settings and initial setup procedures.
Details setting the zero point using reverse measurement for absolute zero.
Explains setting zero with a given angle using the ZERO-OFFSET function.
Covers setting the zero point on a specific reference surface.
Describes how to set a temporary zero based on a corrected value.
Explains temporary zero setting based on a reference surface.
Guide on choosing display units for angles and inclinations.
Instructions for selecting the relative base length for measurements.
How to adjust the filter to reduce signal interference from vibrations.
Procedure for using two linked inclinometers for differential measurements.
Steps for selecting and changing the address of connected sensors.
Guidelines for ensuring reliable measurement results and proper setup.
How to freeze the measured value on the display using the HOLD function.
Setting limits to classify measured values into quality categories (GOOD, LO, HI).
Using the SEND/ESC key to stop ongoing measurement or configuration.
Procedures for modifying or deleting stored correction values like ZERO-OFFSET.
Explains common error messages and special display indicators.
How to transfer measurement data via the RS 232 serial output.
To Next Page