3
Contents
1 Main features 4
2 Operating elements 5
3 Display Field 6
4 Function Keys 6
5 Switching ON/OFF 7
6 Display settings 9
6.1 Summary of the possible display settings 9
6.2 Initial display setting on the centre of gravity through a reverse measurement 11
6.3 Initial display setting on the centre of gravity through a reverse measurement, then in
a given angle α (ZERO-OFFSET function) 14
6.4 Initial display setting on a given reference surface 15
6.5 Temporary reset to zero (relative measurement) on a given corrected value 16
6.6 Temporary reset to zero (relative measurement) on a surface with given references 18
7 Configuring the inclinometer 19
7.1 Selecting the measurement units 19
7.2 Choosing a relative base length 21
7.3 Setting the filtre to attenuate the signal during the measurement operations 22
7.4 Differential measurement with use of two TESA CLINOBEVEL 2 24
7.5 Changing the address of the sensor 26
8 Measuring 27
8.1 General 27
8.2 Blocking the display (HOLD function) 27
8.3 Value classification 29
9 Added functions 31
9.1 Interrupting a measurement operation or a configuring run 31
9.2 Altering or cancelling a correction value 31
9.3 Error messages and further displaying 32
9.4 Réinitialisation des fonctions selon les réglages d’usine (RESET) 33
9.5 Data transfer (SEND function) 34
10 Calibration of measuring system based on 3 reference points 35
11 Delivery Programme and optional accessories 39
12 Technical data 40
13 Declaration of conformity and confirmation of traceability of the values 41
14 Warranty 41
To Next Page
Loading...
