6.4.5 Light
- Press the SET key 12th time to select light unit (lux, fc, w/m2;default:
w/m2).
6.4.6 Temperature
- Press the SET key 13
th
time to select in/outdoor temperature unit,
degree C digits will start flashing, press the WIND/+ or PRESSURE/-
key to select unit (C or F;default: C).
- In normal mode, press the TEMP. key to view wind Chill, Heat Index,
Dew Point Temperature. Press the TEMP. key for 5 second, will register
new transmitter.
Note: every 60 second the unit will measure indoor temperature, indoor
humidity and pressure. If temperature is to lower than minimum range,
will display --.-, if it is higher than highest range, will display --.-.
6.4.7 Wind speed
- Press the SET key 14th to select wind speed unit ( km/h, mph, knots,
m/s, bft;default: km/h ).
- In normal mode,press and release the WIND/+ key to view the wind,
gust and wind direction.
6.4.8 Rain
Press the SET key 15th to select rainfall unit ( inch or mm) the default
mode is mm).
To Next Page
Loading...
