Teuco 620 - Starting Up First Time - Version with Cartridge Filter; Powering Up the System

36
EN
620
               


STARTING UP FIRST TIME - VERSION WITH CARTRIDGE FILTER
1. REMOVE THE CANVAS FROM THE MINIPOOL
See “Minipool Canvas”.
2. ISOLATE THE SYSTEM FROM THE POWER
SUPPLY
Set the main switch to the “OFF” position.
3. CLOSE THE VALVES
Close all section valves along the various pipelines.
4. FILLING THE MINIPOOL
Fill the pool until the water is up to the rim.
5.
Continue lling the pool, allowing the water to spill
over the edge and away to the overow tank.


6.
Open all valves along the pipelines, except for the
system drain valve, and check that there are no
leaks from pipes or ttings.
7. POWERING UP THE SYSTEM
Set the lter pump switch to “STOP”.
Power up the control panel by setting the main
switch to “ON”. The ller solenoid valve will cut in
automatically to bring the water up to operating
level in the overow tank.