51
EN
620
Empty the minipool completely, as follows:
1. Isolate the minipool from the power supply at
the control panel.
2. Open the discharge valves on the spa pumps
(if the pumps are not tted with discharge
valves, partly loosen the ring nuts), on the
compensation tank, on the pipes connecting
the pool and the spa-pack and on the D60
piping inside the pool (if tted).
3. Drain the water from the lter pump by undoing
the plug at the bottom of the prelter basket.
4. Remove water lying on the bottom of the pool,
using a wet vacuum cleaner.
5. Cover the minipool with the canvas provided,
so that it will not collect dirt.
STARTING UP FIRST TIME.
SAND FILTER
Empty the lter of water by removing the external
drain plug. This will ensure that water only runs off,
and not the sand, which is retained by the drain
outlet lter.
CARTRIDGE FILTER
Empty the lter of water by removing the external drain
plug (5).
The cartridge must be removed from the housing,
cleaned, and stored in a dry place.
WINTERING PROCEDURE
2
3
1
To Next Page
Loading...
