Teuco 620 - Heater Operation; Filtration System

43
EN
620
The temperature is set using the selector located on
the heater.
The lter pump continues running until the water has
been heated to the set temperature.
Owing to the considerable amount of water in the
system, a necessarily lengthy interval of time will
pass before any change in selected temperature is
sensed.
There are different ltration programmes selectable, all piloted automatically by the timer at the electrical
panel. Correct initial programming of the control panel is fundamentally important, given that ltration
cycles are programmed according to the day of the week and the time of day.
5 ltration programmes are envisaged.
Three of these programmes are intended specically for home use, whereas the other two are
recommended for intensive use.
In general terms, all programmes include a thorough ltration cycle in the morning and in the evening.
When the pool is occupied by bathers, a condition detected automatically by the system, the lter pump
will come into operation regardless of the programme currently selected.
Similarly, the lter pump and the heater will remain in operation until the water in the pool has been heated
to the set temperature, whatever the time of day (although not during the night, in the case of home use
programmes) and the type of programme selected.


HEATER
FILTRATION
To switch on the minipool water heater, set the
control panel switch to “ON”.
If the heater is in operation, the indicator lights up on
the control panel.
If the heater is not in operation, the control panel
indicator remains off.