Teuco 620 - Programming Stop

41
EN
620
PROGRAMMING STOP
Owing to reasons related to technical service requirements, the program execution may be stopped.
The function is described anyway, as sometimes the system may automatically stop for technical or safety
reasons (e.g. power supply voltage surges).

ENTRY
• Press the “Menu/OK” key.
• Using the keys ▲▼, select the “Run/Stop” menu.
• Select “YES” on the string “Programming stop”.
• The display shows:
BLOCK RELEASING
• Press the “Menu/OK” key.
• Using the keys▲▼, select the “Run/Stop” menu
• Press the “Menu/OK” key.
• Using the keys ▲▼ select the string “Con ini non
volatile”
• Press the “Menu/OK” key to conrm.
12:34 01/03/2015
STOPLD
DATE
12345678