Teuco 620 - Bleeding the Filter

37
EN
620
WATER TREATMENT
8.
Set the pump switch to “MAN” (manual).
Water will begin owing from the pool through the
lter.
9. BLEEDING THE FILTER
Turn the bleed valve located on the the lter cap.
       
         


Repeat the operation several times if necessary.
After bleeding the lter, set the pump switch to the
“AUTO” position.
Treat the water using the products supplied by Teuco, as described in the accompanying manual.
Other equivalent proprietary products can also be used.
The pH value and Chlorine level must be tested chemically at frequent intervals to guarantee the quality
of the water is properly maintained and ensure correct operation of the system.