Using Press-to-Test
Setting Up Test Mode
1. With the graphing calculator turned OFF, press and hold down the ~, |,
and É keys, and then release.
2. The RESET OPTIONS screen displays.
Notes:
• The status bar is blue when in TEST MODE and TEST MODE
ENABLED.
• Pic & Image Vars are disabled.
• Calculator data (Vars) are deleted from RAM and Arc.
• By default:
- ANGLE is set to DEGREE
- STAT DIAGNOSTICS is set to ON
- DISABLE logBASE and DISABLE Σ(are set to YES.
3. To change the default settings, move the cursor over the desired setting
and press Í.
4. Press OK q. The RESET COMPLETE screen displays.
5. On the exam calculator, press Πto verify that applications are disabled.
The following screen displays:
Using Press-to-Test 63
To Next Page
Loading...
