www.ti.com
Functional Description and Operation
19
SPRUI94–January 2017
Submit Documentation Feedback
Copyright © 2017, Texas Instruments Incorporated
XDS110 Debug Probe
Installation path:
.../<CCS Install>/ccs_base/common/uscif/xds110
Usage:
xdsdfu <command> <...>
Supported commands:
• -e
Enumerate connected devices, show info, then exit.
• -m
Switch XDS110 into programming mode (DFU mode).
• -b <FILE>
Download the given bootloader file into the device.
• -f <FILE>
Download the given firmware file into the device.
• -s <TEXT>
Set the XDS110 serial number to given text, any eight character string (no spaces). This option
replaces the entire serial number.
• -r
Reset the XDS110 on completion of another command.
• -? or -h
Show help for these and additional commands.
Examples:
How to examine the firmware in all connected XDS110 probes:
xdsdfu -e
xdsdfu examines all connected XDS110 probes and devices in DFU mode, and reports the details of each
device. Sample output is shown in Figure 11.
Figure 11. xdsdfu Screenshot
To Next Page
Loading...
Need help?
General
