Texecom Veritas Excel Master User Manual

Veritas Excel Master User Guide Operating the Alarm System
INS166-2 7
To CANCEL an Alarm
The display will look like this:
D3$/0$%1#*$.
G"A.%D/00+"<$
12
3
4
56
78
Unset
Tampe r
Zones
Enter your 4-digit Access code
####
, the internal and external
sounders will stop but the external strobe will continue to flash.
! "
If you were not present when the alarm activated, the internal and external
sounders will have already stopped after a pre-programmed time. The system will
re-arm but the external strobe will continue to flash.
To RESET After an Alarm
The display will look something like this:
@A33%B$*
=3/.?0:::::5EL::
12
3
4
56
78
Unset
Tampe r
Zones
@A33%B$*
=3/.?0::::::EL::
12
3
4
56
78
Unset
Tampe r
Zones
! "
The number of the zone that caused the alarm will be flashing (in this case Zone 6)
and the numbers of all subsequent zones violated (if any) will be on (in this case
Zones 7 & 8).
It is advisable to make a note of the zone that caused the alarm as this information
may be required by your alarm company.
To display the descriptive text associated with a particular zone number, press
and hold the corresponding key
#
(LCD keypad only).
Press
,
to acknowledge the alarm, the external strobe will stop, the system will
chime and the display will return to normal.
! "
If the system has been programmed to be reset by an engineer, pressing
,
will not return the display to normal. If this is the case contact your alarm
company.
The system may have been programmed to be reset by Anti-Code, if this is the
case, see page 8 for details.

Texecom Veritas Excel Master Specifications

General

Brand	Texecom
Model	Veritas Excel Master
Category	Security System
Language	English