11
15. Thread tensioner
1. Thread cutting tensioner regulation:
1) After turning tensioner knob [1] to the right
(direction A) the thread remaining in the needle
after cutting will be shorter.
2) After turning the knob to the left (direction B),
length will increase.
3) After turning tensioner knob [2] to the right
(direction C) thread tension will increase.
4) After turning the screw to the left (direction D),
tension will decrease.
2. Bobbin thread tension regulation:
1) After turning the bobbin case spring screw [3] to
the right (direction E) bobbin thread tension will
increase.
2) After turning the screw to the left (direction F) the
tension will decrease.
16. Compensating spring regulation
1. Changing compensating spring stroke [1]:
1) Loosen screw [2].
2) After turning the tension regulation screw [3] to
the right (direction A) spring stroke will increase.
3) After turning the screw to the left (direction B)
stroke will decrease.
2. Changing compensating spring tension [1]:
1) Loosen screw [2] and remove the tensioner from
the machine head.
2) Loosen fixing screw [4].
3) After turning the tension regulation pin [3] to the
right (direction A) - tension will increase.
4) After turning to the left (direction B) tension will
decrease.
17. Manual foot lifter
1. In order to stop the machine with the foot lift-
ed, the manual lifter [1] should be shifted in
direction [A]. The foot will rise about 5.5 mm
and stop.
2. The presser foot will return to its original posi-
tion after shifting the lifter in direction [B].
3. Using the knee lifter, the foot can be lifted by
10 mm (standard), or at a maximum of about
13 mm.
TEXI Tronic 5 operation manual
To Next Page
Loading...
